How to Install WPC Wall Panels – Jiabang
Preparatory work
You will need:
·SILICONE
·RULER
·SPIRIT LEVEL
·CAULKING GUN
·TAPE MEASURE
·RETRACTABLE KNIFE
·MARKER
1 – Prepare your Wall
Before you get started with attaching anything to your wall, make sure you give it a good clean down beforehand, removing any debris or old nails that may be hanging about. Your wall should be completely flat and even before attaching any Panels to ensure the best results.
2 – Measure the Wall
Measure the height and width of the area where you wish to attach your Wall Panels and mark on the felt of the panel where these measurements land, this is where you will cut.
3 – Cut your Panels
To cut the lightweight MDF slats on your wall panels you can simply use a handsaw or a circular saw. To keep the slats in place and ensure a clean cut, we would recommend attaching a strip of masking tape along your cut line. We recommend using a Stanley knife to cut the felt backing on your wall panels. This small tool will provide accuracy for a clean cut. Measure your cut piece against the wall with no adhesive to ensure you have cut the panel accurately and to the right size.
4 – Apply the Board Fix and Attach to Wall
When you’re sure your wall panel fits into position, apply Board Fix to the back of the felt piece in a snake-like format, ensuring it’s evenly spaced down the whole length of the panel. Now, lift your panel up into position (you may want an extra pair of hands for this) keeping it straight, and push against the wall. Apply a small amount of pressure to the panel to ensure the Board Fix has come into contact with the wall, and hold it in place for around 30 seconds to give the adhesive a chance to set and support the weight of the panel.
